I always start with a level nocking point, knowing I can adjust the rest up or down if needed later during the tuning process. Next, attach an arrow level or use a laser-leveling device to confirm and fine-tune. The arrow should run off the string, dead center through the bow’s Berger holes. Now eyeball the arrow more closely, and adjust the arrow’s nock up and down on the string until it looks perfectly level. Next, take one of your hunting arrows, put it on the raised arm of the rest, and then attach it to the string in a spot that looks level. The author uses an arrow level to help find the correct nocking point. Step 3: Level an arrow to find your nocking point. Eventually, you’ll need to serve or otherwise secure a cable-driven rest into the down cable, but don’t do that just yet, because you may want to adjust it first. Most quality drop-away rest will come with good instructions. ![]() When using a limb-driven rest, the limbs will time the rest for you as long as the attachment cord is tight. If you need to slow the rest down, lengthen the cord. If you need to speed up a cable-driven rest, you simple shorten the cord that goes into the down cable. Some rests, like those from QAD, have timing marks to help guide you in this case you need a friend to watch the timing marks as you draw. As you draw, the rest’s arm should reach its vertical position about the same time your bow’s cams roll over to let off. You can use a draw board if you have one, or you can simply draw the bow with a release set not to fire and watch as the rest’s arms come up. Timing a rest is not difficult, but it’s a key step in how to set up a compound bow. If you are using a drop-away rest, you now need to attach the rest’s cable to one of the bow’s limbs or to the down cable, depending on the model of rest you use. The author pulls the cord of a drop-away rest through a bow’s down cable. Just level your bow in a bow vise, follow the rest manufacturer’s instructions to install it to the riser, and eyeball it level. ![]() The good news is that all of them are very simple to attach. Many models still connect to the riser via the bow’s Berger hole(s), but some models, like many from QAD and others that have adapted QAD’s Integrate Mounting System, mount to a pair of dovetail slits recessed into the back face of the bow’s riser. The first step for how to set up a compound bow, arrow-rest mounting has changed significantly over the last three years. This QAD arrow rest is attached to the Berger hole, but other models can be installed via a dovetail mount. How to Set Up a Compound Bow, Step-By-Step Step 1: Attached the arrow rest. (You don’t have to do the latter, but I prefer this order.) Once that’s done, all you have to do is follow these seven steps for how to set up a compound bow. That means there isn’t much more for you to do than attach accessories and properly tie in a D-Loop and peep sight.īefore I set up any compound, I like to first give the check the bow over thoroughly to make sure it’s in good working oder, and I like to choose and build my hunting arrows. I set up and tune between 15 and 20 bows annually, and I can tell you many if not most bows are cam-timed perfectly out of the box. Modern bows are remarkable machines crafted to exact specifications, and today’s accessories are no different. We’ve got you covered. Learning how to set up a compound bow and tuning it is actually easier than ever before. If that seems a little intimidating, don’t worry. That is, if you know how to set up a compound bow properly. It’s sure to improve your confidence going into next season, and probably your bow’s performance, too. ![]() ![]() Or maybe you’re planning to upgrade the accessories on your current bow. So, you got a new compound bow for upcoming hunting season. We may earn revenue from the products available on this page and participate in affiliate programs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |